Great experience! My garage door was off track and needed new rollers. The technician did an excellent job, and now the door works perfectly. Fast, professional service at a fair price. Highly recommend!
Shiri Cohe
Bent or corroded tracks make a door stick, grind or jump the rail. Our garage door track replacement restores straight, manufacturer-spec travel.

Fully stocked trucks across the Lowcountry - springs, cables, rollers and opener parts ride with every technician.
Repairs, replacements and new installations - residential and commercial, across Charleston and the surrounding areas.

Snapped or frayed lift cables replaced and re-tensioned so the door runs level.

Torsion and extension springs replaced in matched pairs, sized to your door.

Gears, sprockets, trolleys, safety eyes and travel limits put right.

Chain, belt and wall-mount openers fitted and programmed.

Doors off the rail reset safely, with the track checked for damage.

Sealed nylon rollers that run quieter and outlast steel by years.

Worn or cracked hinges swapped before they pull the section out of line.

Bent or corroded track replaced and realigned to manufacturer spec.

New bottom seal to keep water, draughts and pests out of the garage.

Dented or damaged sections repaired where a full replacement is not needed.

Individual sections replaced and colour-matched to the existing door.

Insulated steel, carriage house and full-view glass doors, measured and fitted on site.

Door stuck open or car trapped inside? You go to the front of the queue.

Annual tune-ups that catch worn parts before they strand you.
Tracks guide the rollers and keep the door square as it travels. Once a track is bent or rusted through, no amount of adjustment keeps the door running smoothly.

A damaged track shows as a door that sticks or grinds at the same spot, pulls to one side, or leaves a gap where the rollers no longer sit square.
Look for visible bends, dents, or rust eating through the rail, and brackets that have worked loose from the wall or ceiling.
When the track is the problem, the door fights it on every cycle, which wears the rollers and risks a derailment.

Sticking at one spot, pulling to one side, or a visibly bent rail all point to track trouble.
We inspect the track, brackets, rollers and cables to see what is damaged and why.
You get the full cost in writing before any work begins, including any rollers the track has worn.
We fit new track to spec, re-secure the brackets, and cycle-test the door so it runs straight.
A bent rail pinches the rollers and makes the door stick. Light bends can sometimes be straightened; bad ones are replaced.
Salt-air rust weakens the track until it flexes and misaligns. We fit galvanised track built for coastal homes.
Loose or shifted brackets let the track move. We re-secure and realign them to manufacturer spec.
A track bent once is weakened at that point. Bending it back leaves a weak spot that soon fails again.
Tracks must sit at an exact distance and angle. Guesswork leaves the door binding or jumping the rail.
A deformed track grinds the rollers flat, so track work usually pairs with a roller check.
The price depends on how much track is damaged and what caused it.
We replace garage door tracks across Charleston County and the surrounding Lowcountry. See the full list of areas we cover, or call and we will confirm we reach you.
Tell us what the door is doing and we will get a technician out to handle your garage door track replacement and test the door through a full cycle.
843-830-1627